EROWA Wire EDM Tooling at work
The right equipment for every application: well-thought-out combinations of chucks, clamping elements and jaws will clamp any conceivable workpiece.
- Flat chuck with adjustable jaw.
- Special holder for cylindrical parts. When fitted to the pendulum holder, a workpiece can be adjusted in three axes.
- With the Z-Vario, every workpiece can be positioned at the right height.
- The RSA chuck is the basis for loading ITS elements onto the WEDM center.
- Special workpiece supports can be fitted to the clamping beam in a flexible manner. The EDM wire is threaded through the grooves.
- Mini spacer support for smaller workpieces.
- Single-part palletization in the manned shift, where tricky jobs are done.
- Multiple palletizing increases machine autonomy. Unmanned shifts are put to optimal use.
- Big workpieces are clamped individually.
- Flat chuck with free access of the wire guide.
- Chuck with clamping part continuously adjustable round 360°.
- The angled clamping unit is continuously adjustable round 90°.
- The pendulum holder can be adjusted in all axes.
- Clamping like in a chuck, with threaded rods and clamping beams.
- The chucks constitute the interface between machine table and workpiece carrier.
- Various chuck versions (manual / automatable) for all requirements.
- There is a wide range of tooling system basis kits for all established WEDM centers. We'll gladly advise you!
- EROWA's wide range of accessory sets contains a number of practical and favorably priced aids that make clamping work a pleasure.
- Workpiece presetting saves time.
- Elaborate presetting and measuring jobs can be done on an EROWA 3D measuring station.
- With the EROWA Lift, you can load WEDM centers with heavy clamping frames.
- Large magazine store for automatic machine loading.
- EROWA Robot for more machine autonomy during night and weekend hours.
- A workpiece carrier is precisely positioned on the chuck.
